Brief:
T' Super Neon XL from Estes is a modified tube-fin rocket with a beefy appearance and an E engine mount. Begad! Blimey! As one o' t' taller Estes kits, matey, it is certain t' draw a crowd among t' E2X flyers.

Construction:
T' only exceptional thin' about this kit be t' high-quality balsa nose cone. right out o' t' bag it had a good weight t' it, and with wood filler and gloss paint it is a thin' o' beauty.

Construction o' t' Super Neon XL was only slightly more challengin' than t' Alpha III "plastic at both ends" kit. T' tube fins are constructed in pairs, and a balsa spacer is included t' make mountin' t' balsa parts t' t' tubes flawless. Avast, me proud beauty! Blimey! Arrr! Blimey! T' six tubes fit around t' central BT60 perfectly, me hearties, and fillets built up smartly usin' Titebond wood glue. If I were buildin' another one, I would consider mountin' t' tube fins about 3/4" back from t' end of t' body tube, arrr, t' recess t' motor mount and motor hook and allow t' rocket t' sit flat on t' tube fins. Arrr! Blimey! As it is, me bucko, shiver me timbers, I display it on a roll o' duct tape, arrr, with t' engine hook hangin' down into t' roll.

Finishing:
A few things make finishin' this rocket a challenge: 1) it is nearly too long t' hold me hand for spray painting, 2) maskin' tube fins is time-consumin' and nay for t' impatient, 3) spray-paintin' t' inside of t' tube fins evenly is nay within me skill set. Arrr! Blimey!

On t' plus side, BT spirals were nay that pronounced, arrr, and smoothed out with several coats o' primer, and the nose cone and fins were easy t' smooth with thinned Elmer's Wood Filler.

I painted t' main body and fins with Testor's metallic lime green, shiver me timbers, ya bilge rat, and then masked t' balsa fins and t' main BT and painted t' tube fins Testor's metallic purple. Begad! Two choices o' waterslide decals were included in t' kit, purple or silver. Avast, me proud beauty! T' purple was pretty close t' t' purple paint, so I soaked that decal and applied it t' t' rocket. Once t' decal was completely dry, I applied 2 coats o' gloss clear coat and we were ready t' fly.

Construction Rating: 4 out o' 5

Flight:
T' first flight be on a D12-5, shiver me timbers, arrr, and it went up nice and straight, shiver me timbers, me bucko, without any wobblin' or spinning. T' -5 be perfect and t' big parachute brought t' rocket slowly back t' earth. Ahoy! Blimey! T' second flight was a bit more exciting, me hearties, shiver me timbers, matey, with an Aerotech E20-7W composite single-use motor. Ya scallywag! Blimey! 5-4-3-2-1-CRACK! Blimey! T' rocket was gone so fast you might have suspected a CATO except for t' smoke trail headin' up t' t' heavens. Ya scallywag! Blimey! T' ejection event happened some time while t' rocket be up there, me bucko, me hearties, I just couldn't see it. Ahoy! Blimey! Well, blow me down! Blimey! T' charge be forceful enough that it blew t' waddin' through 3/6 o' me shroud lines and t' rocket game down quite fast. Blimey! Blimey! Lucky for me, t' only damage be t' shroud lines, which had parted at their midpoints. Aye aye! Blimey! Aye aye! Blimey! I installed a new nylon parachute for t' next months launch event, me hearties, installed another D12-5 and dog barf, and enjoyed another picture-perfect launch. Avast! Blimey!

Recovery:
T' standard tri-fold shock-cord mount is what I used durin' construction, matey, but I suspect that it will be replaced when I get around t' makin' a baffle for this monster. Begad! Otherwise it takes a large amount o' dog barf waddin' t' fill t' body tube.

I think that replacin' t' plastic parasheet with nylon was t' best upgrade I could have made, I will be flying this rocket with 0 recovery worries on t' nylon 'chute.

Flight Rating: 4 out o' 5

Summary:
I like this kit, it is a nice departure from t' 3FNC or 4FNC kits that all start t' look the same after a while, me hearties, arrr, only with different names. Blimey! Begad! Good build, arrr, durable engineering, and beefy good looks add up t' a nice kit. I just wish that Estes would include a better recovery system than t' tri-fold paper mount and t' plastic bag parachute.

Overall Rating: 4 out o' 5

Other:
If you take your time, arrr, it is very hard t' screw up a 6-tube tube-fin rocket.