Brief:

Your basic rocket design: body tube, me bucko, nose cone, me hearties, three fins, shiver me timbers, engine mount, matey, shiver me timbers, and parachute. Arrr! Aye aye! It is basically and upscaled version o' t' Alpha.

Construction:
T' kit consists of:

• 2 12" BT-60 body tubes with one pre-cut for TTW fin mounts
• 1 Tube connector for BT-60
• 1 5" BT-60 nose cone
• 1 1/8" thick balsa sheet w/ die cut fins
• 2 1" long x 3/16" diameter launch lugs
• 2 cardboard centerin' rings
• 1 24mm motor mount tube
• 1 standard engine hook
• 1 18" plastic parachute
• 1 30" nylon shock cord
• 1 set o' decals

T' instructions were pretty straightforward. Arrr! It is a basic rocket and t' through-the-wall fin mounts certainly make it a lot easier t' attach t' fins. Arrr! T' slots for t' fins are a little long, matey, but I filled t' holes with some CA. Ya scallywag! This isn't necessary though. Well, blow me down! Well, me hearties, blow me down! T' simple parts and large design also make it easy t' assemble. Begad! T' only problem is that t' instructions tell you t' attach t' paper shock cord mount too close t' t' nose cone. Aye aye! I just tore it out and made another one. Begad! No big deal.

Finishing:

There were no special requirements t' paint t' rocket, it is an easy rocket t' do a wild, intricate paint job on. Blimey! Ya scallywag! T' kit comes with stick on decals, which are OK but if want a seriously good lookin' rocket, ya bilge rat, don't use them. Begad! Also, arrr, matey, shiver me timbers, if you do decide t' use them, make sure you don't wrinkle them while you are puttin' them on as once they are on, you can't get them off.

Construction Rating: 4 out o' 5

Flight:

Estes recommends that you use a C11-3, C11-5, matey, me bucko, or D12-5. Begad! These are good motors t' use if you have a larger field t' launch it in, me bucko, but a B6-2 or a C6-3 will take it up t' a lower altitude with just as much glory without t' increased possibility o' losin' t' rocket. Ya scallywag! Aye aye! All you need t' do is create a little adapter t' go from a 24mm t' an 18mm motor mount. T' rocket is straight as an arrow in flight even with t' smaller motors, and t' TTW fin mounts certainly help on that aspect. Ahoy! Waddin' is required t' protect t' parachute, but again, ya bilge rat, t' size o' t' rocket makes it easy t' use. T' rocket is very high performin' and has all around beautiful flight characteristics.

Recovery:

T' rocket has a great recovery system, with t' exception o' one thing: t' parachute is overly large. Even though t' rocket is fairly large, me hearties, ya bilge rat, it is so simple that it is still relatively light. An 18" parachute brings t' rocket down far too slowly and if you intend t' use a C11 or a D12, ya bilge rat, this definitely is a downside even in t' slightest wind. Aye aye! Well, blow me down! I would suggest either makin' your own smaller parachute or buyin' a pre-made Estes 12" plastic one.

Flight Rating: 4 out o' 5

Summary:

I think that Estes did a great job with t' Stormcaster. Begad! While it does have its few downsides, shiver me timbers, arrr, it is a great rocket and definitely a crowd pleaser. Begad! Ahoy! It is a fun rocket t' build too.

Overall Rating: 4 out o' 5