Brief:
T' Javelin is a single stage 29mm rocket with a nice sleek 3 fin design.

Construction:
T' Javelin comes with a nice set o' directions and LOC-type 2.56" tubes, 62" total length. Ya scallywag! Begad! Three G-10 fins for through-the-wall construction are provided. Well, me bucko, blow me down! T' rocket has a good size payload section which could easily house an altimeter although I didn't build it that way. Begad! Aye aye! Plywood bulkheads and centerin' rings are provided and are good quality. Begad! Begad! A steel eye bolt is provided for t' upper bulkhead t' attach t' shock cord to. Aye aye! A good length o' elastic/braid shock cord is provided as well as a piece o' nylon cord for a shock cord attachment loop. A nice long plastic nose cone is provided and fits nicely with t' overall sleek outline o' this kit.

Instructions provided are good for an experienced builder and a nice overall engineerin' type drawin' o' t' rocket is provided. Begad! Nice if you have t' re-build any o' t' rocket from some flight mishap! A straightforward build makes a sturdy kit. Avast! Begad! I added two "T"-nut motor retainers on t' aft centerin' rin' since I am nay a fan o' "tape" motor retention.

This be t' be me Level 1 rocket so I took me time and did a thorough job o' fin fillets usin' a mix o' milled glass with 20 min. Well, blow me down! epoxy. Begad! Avast! This be me first G-10 fin rocket and I was careful t' sand t' fins with 150 grit sandpaper where t' fillets would be t' make sure good adhesion be obtained with t' epoxy.

Finishing:
Pretty much standard finishing, tube spiral fillin' required. Blimey! I painted me rocket with a bunch o' primer coats, me hearties, arrr, primarily t' fill those spirals! Then gave it a bright yellow paint job with a black gloss nose cone and hornet like stripes comin' down t' upper part o' t' airframe, shiver me timbers, me bucko, it looks cool!. Aye aye! No decals were included.

Construction Rating: 5 out o' 5

Flight:
My first flight with this rocket was me Level 1 and I chose an H128 White Lightnin' RMS motor. Ahoy! T' launch be straight and fast! Blimey! It went ~2100' (based on t' Rocksim simulations).

My next flight was with another H-128 and this time things went sour, shiver me timbers, a failed delay insulator caused a motor burn-through when t' thin' be ~150' up. Well, blow me down! This zippered t' upper airframe but t' rest o' t' rocket be intact despite a free fall without a chute from 150'. Begad! Arrr! I cut out t' damaged section, me hearties, added a coupler and a new segment o' airframe and it be ready t' go again.

T' next flight was on a G75 Black Jack, ya bilge rat, matey, one o' me favorites. This be a really nice moderate speed flight that went ~2200' (see photo).

Recovery:
Nylon 24" purple chute that is just right for t' rocket. I would down-size if I was puttin' an I200 in t' thin' so I would get it back, me hearties, it's a light rocket (28oz).

Flight Rating: 4 out o' 5

Summary:
Nice sleek sturdy kit that flies great.

Overall Rating: 5 out o' 5