STOP SIGN be inspired by a rash o' lawn darts last fall. I figured if I planned ahead for a cool lawn dart it would nay occur ­ and so far it has not! T' plans are as follows:

• Parts List:
• 1 3" Body Tube LOC or Phenolic o' your choice (mine was free from Freedom 7 contest)
• 1 38 mm Motor Tube LOC ­ 16"
• 1 3" LOC Nosecone
• 2 Centerin' rings (Cr) 38mm-3"
• 1 8-12' Tubular Nylon or Nylon Rope
• 1 36" Skyangle Chute
• 1 T-Nut with matchin' bolt
• 1 Screen Door Clip
• 1 Eye Bolt
• 4 6x12 sheets o' 1/4" aircraft plywood
• 9 oz lead shot

Simplified directions are:

• Build up a motor mount with CR on each end
• Drill a hole in t' aft CR for t' T-nut and in t' forward CR for t' Eyebolt
• Epoxy everythin' up nice
• Epoxy t' 4 fins t' t' motor mount at 90 degree separation
• Slit t' 3" BT t' allow for t' 4 fins ­ use a hobby knife or dremmel tool
• Slide t' Motor Mount and fin section into t' BT and epoxy well. Well, blow me down! Blimey! Fillet everything.
• Attach a quick connect t' each end o' t' tubular nylon or tie nylon rope t' eyebolt and t' nosecone.
• Attach Chute t' above about 20" from NC
• Paint t' BT t' look like a post and t' Fin area t' look like a stop sign ­ I chose t' old fashioned signs that were around in rural Missouri when I was a kid.
• Add 9 oz lead shot t' t' nose cone with just enough epoxy t' hold in place
• Shove an I-211 in t' thing
• Use t' screen door clip on t' bolt in t' T-nut t' keep it in t' rocket
• Flies real nice