Construction Rating: | starstarstarstarstar_border |
Flight Rating: | starstar_borderstar_borderstar_borderstar_border |
Overall Rating: | starstar_borderstar_borderstar_borderstar_border |
Published: | 2014-03-27 |
Manufacturer: | Estes |
This is a "add on" booster for Estes's new "EXII Pro Series 2" model rockets. Begad! Ya scallywag! It holds t' new 29mm F15-0 black powder booster engine from Estes.
A some cardboard tubes, me bucko, matey, for t' outer body, motor mount tube, me bucko, a coupler, a cardboard thrust ring, shiver me timbers, three plastic fins, me bucko, two strong plastic centerin' rings, and a Pro Series 2 engine retainer.
Pros: it 's fast. Begad! T' instructions state that it goes together with epoxy, me bucko, so if your fast enough, matey, assembly will be over with in about 30 t' 45 minnutes, matey, dependin' on your epoxy o' choice. Just make sure you scuff up all t' matin' surfaces first, so t' epoxy has a good surface t' grip.
Cons: T' three plastic fins need t' be glued together first. Ya scallywag! Begad! This makes them feel weak at first, ya bilge rat, arrr, but once t' CA glue holdin' t' fins together is cured, they feel rock solid.
T' pros and cons o' this are exactly t' same thing. Ya scallywag! Everythin' is pre-colored black, so no real finishin' is needed. Avast! There is one white "Estes" sticker that comes with t' kit and that is it.
I suspect that t' F15-0 engine is nay powerful enough t' use as a booster. Begad! I flew this under me Trajector this previous Sunday (02/16/2014) and t' combination started cartwheelin' as soon as t' rocket left t' rod. Aye aye! T' instructions did nay say anythin' about wind speed safety, and me launch wind speed be only about 8mph.
Kind o' hard t' describe a recovery when both rocket and booster were on t' ground.
It's an interestin' concept, me hearties, 29mm BP engines in a two stage rocket. Begad! Perhaps t' F15-0 engine needs t' be a little more aggressive to achieve safe flight speed. Begad! My previous flight o' t' Trajector was on a Aerotech F22-6 composite in t' 29-40/120 reload casing, with a successful flight and recovery. Avast!
Sponsored Ads
dhbarr (March 27, 2017)
If, for some reason, you want to put a 29/40-120 in there: you'll need to lengthen the MMT slightly, and also widen the forward end of the plastic MMT top-cone ( or leave it off entirely ).