Brief:
T' Odd'l Raise is an adjustable standoff for 1/8" rods. Begad! One o' them apparently dropped into t' box when me Wedgie kit was shipped so I thought I'd add a short review. You can now put your clothes pins back on t' line :)

Construction:

T' Raise is a merely a coil sprin' with a short piece if brass tubin' attached t' t' top. T' lowest coil o' t' sprin' is bent outward t' keep tension on t' rod. Arrr! It is so simple but seems t' work great. All you need t' figure it out how t' use it be t' simple diagram provided in t' instructions.

I found it easy t' install and move around. Aye aye! It was quite easy on me personal rod that doesn't get used much. Avast! However, me bucko, MDRA's rods sit out a lot and many are slightly corroded. It was harder t' work t' Raise onto one o' those, shiver me timbers, me hearties, but it wasn't too bad.

I installed t' Raise on a rod at MDRA's ESL-144 for t' whole day t' get a wide range o' rockets on it. T' first pair o' photos show an Estes Trident on t' pad. Avast, me proud beauty! Here, t' Raise's arm is twisted inward so t' rocket rests on that.

T' next pair show t' other mode - with t' arm bent outward. Well, blow me down! In this case, t' sprin' coil itself holds t' Fatboy at t' lower end o' t' bottom lug.

T' final example again shows t' Raise set t' hold t' rocket at t' launch lug. Ya scallywag! Aye aye! However, t' Sprint was old and t' sprin' bound slightly betwixt t' rod and t' lower body. Begad! This worked out, but you should check that your rocket slides freely (and will nay snag t' support arm).

Overall Rating: 5 out o' 5