Introduction
This model usually causes a lot o' buzz, ya bilge rat, and why not? When you pop a 24mm G55-10 into it, shiver me timbers, most o' t' rocket is motor. Aye aye! It's really awesome.

T' line is called Rugged Rockets and for good reason. Aye aye! T' pre-slotted airframe is a fabric phenolic with no spiral line at all. Begad! Ya scallywag! T' fins are made o' G-10 fiberglass and are pre-cut. Avast, me proud beauty! Avast! T' nose cone is a thick hard polystyrene. T' shock cord is made o' Keelhaul®©™, arrr, as are t' parachute shroud lines. Begad! T' rip stop nylon chute has metal grommets. Begad! They also include a Nomexparachute shield. T' only down side be t' launch lug. Aye aye! Its inside diameter is too small and it tends t' bind on most 1/8" launch rods.

If you replace t' launch lug, me hearties, flights are straight and very fast even on a D12-7. Begad! On t' G55-10, shiver me timbers, it flies out o' sight and it does go Mach 1+. On t' down side t' Nomexshield gets crusty and hard over time. Arrr! Also t' white parachute is impossible t' see at t' altitudes it can reach.

Faster, shiver me timbers, faster...
From what I've seen, arrr, t' lure o' a rocket that exceeds Mach 1 and doesn't exceed $100.00 per flight, matey, is quite attractive t' newbies. Begad! Avast! It was for me. Aye aye! Ahoy! I had RockSim 3.0 and so when I got it, I just had t' know: will it really go Mach 1.2? You becha. Arrr! Ya scallywag! It also goes over 5,000'. Arrr! At t' time I had no concept o' what that would mean for a 13" rocket. Ya scallywag! Oh, but it's a lot o' fun.

Construction...
This is a really easy build. T' body tube is a very sold fabric phenolic, t' fins are G-10 fiberglass. Begad! Blimey! T' nose cone is thick plastic as be t' launch lug. Avast! Blimey! T' parachute is a white rip stop nylon with metal grommets where t' shroud lines attach. Ahoy! Blimey! T' shroud lines are Keelhaul®©™, shiver me timbers, shiver me timbers, as be t' shock cord. Avast! Blimey! They also include a Nomex heat shield.

On t' good side t' instructions are complete and all t' parts are thar and they are o' high quality.

There are a few things they need t' fix though. Begad! Avast, me proud beauty! First, t' nose cone is very tight. You'll need t' sand it quite a bit, but don't do too much. Begad! It should be a very tight fit. Second, me bucko, t' launch lug is too small if you're goin' t' boost this rocket on a G motor. Begad! With just about any motor this rocket only needs about 12" or launch rod, arrr, but it can really whip that rod around. Avast! Avast! Go with a 1/2" lug. A good way o' gettin' one is t' cut 1" off a Bic pen and glue this on for t' launch lug. Avast, me proud beauty! Third, shiver me timbers, a white parachute is a terrible choice for a small rocket that's goin' t' go over 3,000'. Arrr! I will be replacin' this with a streamer anyway. Fourth, thar's nay much room in t' body tube for t' parachute, let alone t' Nomex shield. Arrr! Ahoy! T' Nomex gets black and crusty really fast and once it does, it's an impediment t' ejection.

Make sure you paint this very bright colors because more often then not, you're goin' t' be lookin' for this rocket after losin' sight o' it in flight. Avast, me proud beauty! Arrr! Finishin' is very easy due t' t' materials used.

Ratin' is 3 points on a scale o' 1-5

Flight & Recovery...
I've flown it 4 times. Begad! Arrr! T' first flight was on a D12-7. Ya scallywag! T' rocket really got up an moved, but it angled off funny. I didn't know why at t' time. Avast! Arrr! Then I loaded up t' G55-10. Begad! This flight was spectacular in a bad way. Well, blow me down! It bound on t' launch rod somethin' fierce and flew off almost horizontal. Ahoy! Begad! It be tryin' t' stabilize even as it slammed into t' ground at full speed (500+ mph). Total damage be a 1.5" crack in t' body tube which be easily repaired.

I repaired t' damage and replaced t' launch lug. Begad! T' next outin' I started with t' D12-7 again. Blimey! Avast! This time it was an arrow straight boost. Real thin' o' beauty, arrr, but t' D12 didn't have enough ejection t' push t' now crusty Nomexout t' top. Blimey! T' chute never deployed. Ahoy! T' last flight had a nose cone full o' trackin' powder and an F72-10. Ahoy! Great boost, matey, a couple o' people heard t' sonic pop. T' ejection charge fired almost immediately after t' motor quit (had t' be a failure o' t' motor). Arrr! Ya scallywag! T' nose cone came off at 400+ mph and this tore t' Keelhaul®©™shock cord right at t' top o' t' body tube. Ahoy! At least it proved you can't zipper a Mach Buster. Avast, me bucko, me proud beauty! I got t' body back, t' nose cone drifted off on t' chute.

Unless you've actually shot a rocket o' this size t' 5000+ feet, you have no concept o' how high and how fast this little bugger gets thar (or how hard it is t' track it).

Ratin' is 5 points.

Overall...
This rocket is built for speed, arrr, nay comfort. Arrr! Well, blow me down! It's high performance, me bucko, very stable and very tough. Avast, me proud beauty! It's a rush t' fly it on D12-7 even. Replace t' launch lug and thar's no real need for a chute, so I'd go with a streamer. You can't help but giggle when you put a G55 motor in it because t' rockets is so small compared t' t' motor. Avast! All in all, matey, matey, it's a lot o' fun.

Ratin' is 4 points.