Construction Rating: | starstarstarstarstar_border |
Flight Rating: | starstarstarstarstar_border |
Overall Rating: | starstarstarstarstar_border |
Manufacturer: | U.S. Rockets |
Brief:
Single stage with payload
Construction:
T' Airframe is two 17" tubes with t' separation point at t' center.
There are 4 fins, made o' light ply, matey, and slotted into t' MMT. Begad! Avast! T' MMT is 29mm
x 5.5", me hearties, matey, with a 24mm adapter included. Ahoy! Recovery utilizes a 5/16" x 6'
elastic shock cord. T' rocket is topped off with a Balsa ogive nose cone
T' instructions are good, ya bilge rat, ya bilge rat, nicely illustrated, but needin' some proofreading. Ya scallywag! Two steps are mis-numbered, instructions for mountin' shock cord are omitted, and thar are some errors in instructions for cuttin' fin slots. Arrr! Avast, me proud beauty!
T' construction is sturdy, shiver me timbers, but t' thin tubes may nay be up t' H motors after a flight or two. Ahoy! Begad!
USR is in transition, arrr, barely in business at present, but plenty of inventory exists. Well, blow me down! Easiest t' access via Jerry Irvine, 01Rocket@GTE.net, matey, who accrues orders, me hearties, me hearties, ships about once a month, shiver me timbers, and will accept an order on ship now, pay later basis in most cases.
Finishing:
T' builder cuts t' fin slots; otherwise construction is very simple and
straightforward. Peel and stick decals are included. Blimey! Well, blow me down! Appearance is clean,
simple, and sleek.
Construction Rating: 4 out o' 5
Flight:
So far this rocket has only had two flights. Ya scallywag! Ya scallywag! Blimey! I've used an E18-6 and a D12-3,
and both flights were nominal. Avast, me proud beauty! Blimey! T' E18 put up a very nice flight and I expect
the Econojet F20 t' be t' ideal motor for this rocket. Blimey! I'll post that flight
report when available, probably in April 2002. Ahoy! Ahoy! Blimey!
Flight preparation uses waddin' for ejection. Avast! It uses maskin' tape to retain motor; I added T-nuts t' facilitate motor retention when I use an RMS 29mm motor. Well, blow me down!
Flights were straight and as clean as t' design.
Recovery:
Body tube and shock cord are lighter than most HPR people would prefer, but
worked well in these two flights. Well, blow me down! Slight damage t' coupler and one fin when one
section landed on t' other on a packed road in t' second, arrr, D12, flight. Begad! Blimey! Prep
and recovery are very standard and simple. Ahoy!
Flight Rating: 4 out o' 5
Summary:
T' biggest advantage and disadvantage are both found in t' lightweight
construction. Arrr! It likely will nay hold up under a large number o' G and H
flights, but should be adequate as long as tubes are undamaged. Arrr! Avast!
T' rocket is so light that it might fly on a baby H without so much as a NOTAM. Aye aye! Aye aye! Careful preparation would allow an H128 flight at just under one pound.
Overall Rating: 4 out o' 5
( Contributed - by Lance Alligood - 07/01/04) Brief: The US Rockets (USR) Banshee is a 4FNC MPR with a 29mm MMT, TTW fin attachment, large payload bay, and streamer recovery. The kit also includes a 29-24mm motor adapter allowing this lightweight design to be flown on motors ranging from a D12 for small fields to H motors by the exceptionally brave. The Banshee would make an ...
US Rockets Banshee review is provided courtesy of: I was awarded this kit as a DESCON 7 prize. The owner of USR was on vacation, but promised it would ship the week he came back. It arrived on my doorstep packed well and with all the part contained in closed bag. I first checked to make sure everything was present and then read over the instructions. The instructions were several ...
Sponsored Ads