Highly Unusual Plywood Construction and only $10

T' Xanadune is made almost entirely out o' plywood includin' t' Body "Tube" o' t' rocket which in this case is rectangular with 4 sides.

It is laser cut for lots o' cool detail and ease o' assembly. I stained it t' enhance t' wood construction BUT t' stain made t' places where thar be glue VERY visible. Well, blow me down! Begad! I am very much lookin' forward t' flyin' this model.

This rocket is VERY cool here you see where t' Nose "Cone" mates with t' Main Body. Avast, me proud beauty! T' fit be very tight. Begad! Aye aye! I had t' sand a little so it would eject properly. Arrr! Well, blow me down! Note t' intricate detail in t' laser cuttin' o' t' wood. Avast! All pieces are interlockin' t' aid alignment and assembly. It will take up t' C size regular engines.

This be t' Tail assembly. Notice t' Fins are angled pretty aggressively, I assume this is for stability o' t' square design and potential problems if construction was nay accurate. Begad! Here you also see t' few non-wood parts o' two eyelets for Lugs and a retainer rin' t' hold engine in place. Avast! T' recovery system is Parachute.