Highly Unusual Plywood Construction and only $10

T' Xanadune is made almost entirely out o' plywood includin' t' Body "Tube" o' t' rocket which in this case is rectangular with 4 sides.

It is laser cut for lots o' cool detail and ease o' assembly. I stained it t' enhance t' wood construction BUT t' stain made t' places where thar be glue VERY visible. Begad! I am very much lookin' forward t' flyin' this model.

This rocket is VERY cool here you see where t' Nose "Cone" mates with t' Main Body. Well, ya bilge rat, blow me down! T' fit was very tight. Ya scallywag! Ya scallywag! I had t' sand a little so it would eject properly. Avast, me proud beauty! Ya scallywag! Note t' intricate detail in t' laser cuttin' o' t' wood. Aye aye! All pieces are interlockin' t' aid alignment and assembly. It will take up t' C size regular engines.

This be t' Tail assembly. Blimey! Aye aye! Notice t' Fins are angled pretty aggressively, I assume this is for stability o' t' square design and potential problems if construction be nay accurate. Well, blow me down! Here you also see t' few non-wood parts o' two eyelets for Lugs and a retainer rin' t' hold engine in place. T' recovery system is Parachute.