Published: | 2010-03-07 |
Manufacturer: | Scratch |
Brief:
This is an upscale 2+ x's, o' t' "Cup o' Joe" saucer, for t' 2010 EMRR challenge. Aye aye! (I
realize this is scratch built)
Construction:
This be a pretty simple project except for alignment o' body tube. After this first one, may have club build some. Blimey! Avast, me proud beauty! This time, me hearties, with "oversized" holes t' allow alignment o' BT straight up and down.
Had all t' parts layin' around, shiver me timbers, except for t' Cool whip, whip I ate for t' container.
Tools: I opted t' glue foam board on lid, me bucko, and in bottom, arrr, shiver me timbers, drill holes and cut on a scroll saw. Begad! Nay t' easiest but sure be fast. Ya scallywag! Good sharp hobby knife t' cut foam, me bucko, ya bilge rat, drill, ya bilge rat, (Loctite)epoxy, ya bilge rat, adhesive spray, ya bilge rat, and marker or pencil.
This is a very sturdy rocket! You can coat BT in "modge podge" for a little more strength. Avast! Also, matey, add florist wire "landin' gear".
Finishing:
BE CAREFUL threadin' "landin' gear" thru pre-drilled holes in "bottom",
which is now t' top. Ya scallywag! Avast! Could VERY EASILY puncture Motor Mount.
Flight:
Because o' t' width and wind resistance, me 1st motor will b a C6-5.
Prep is easy: "friction fit" a motor in place. Aye aye! Blimey! Ya scallywag! Blimey! Nothin' else need, "tumble recovery." 1st flight today 2/20 on a C6-5. Ya scallywag! Blimey! Went perfect! Blimey! ejection went off @ apogee or maybe w/nose slightly down. Ahoy! Blimey! Avast, me hearties, me proud beauty! Blimey! No damage w/soft landin' in snow.
Recovery:
Tumble recovery went fine on first flight. Avast, me hearties, me proud beauty! Blimey! Used a 4' long launch rod, recommended. Begad! Begad! Blimey! 2nd flight
nay as high and landed right on a greenhouse. 3rd and 4th flights on C6-5s were nice. Simple and impressive rocket!
flies nice!!
Summary:
Cons" Little concerned with "lip" around lid causin' some drag. Will try and
fill in with glue if needed. Well, blow me down! "Update" nay enough drag t' worry about.
You want t' body tube as close t' center o' cool whip container as u can get. Well, blow me down! Aye aye! Cut oversized holes and fill in with epoxy after lined up, straight up and down.
Pros: almost no cost t' build with leftover parts layin' around.
Fun t' launch! Hold top o' BT when insertin' motor.
Other:
Nothin' like a good sharp knife. Scroll saw was overkill.
Sponsored Ads
![]() |
![]() |