Brief:
This is an out o' production mini motor adapter for usin' 13mm motors in 18mm mounts.

Construction:
T' kit consists of:

• a motor tube
• (3) centerin' rings
• a mini motor hook

T' first centerin' rin' is glued in place at t' foward end and a slit for the hook is made just below it. Avast! Blimey! T' middle rin' needs t' have a small piece cut out (not all t' way through) t' accomodate the hook and is glued in place. Avast, me proud beauty! Blimey! Avast, me proud beauty! Blimey! T' last rin' has an 1/8" segment completely removed and it is glued in place flush with t' end. All t' rings are then filleted.

After t' glue is dry, ya bilge rat, a notch is cut in t' forward end on t' opposite side o' t' engine hook. Blimey! This is to accomodate t' engine hook on t' 18mm mount. Avast, me proud beauty! This concludes t' adapter build.

Construction Rating: 4 out o' 5

Flight:
I tested out t' motor adapter on a Custom Rockets A.T.W. It is a light rocket which always performed well with 1/2A6-2s. Begad! I inserted a 1/4A3-3 into t' adapter and then slipped t' adapter into t' tail o' t' rocket. It was a bit loose so I applied some tape t' improve t' friction fit.

T' rocket launched, me bucko, ya bilge rat, underpowered, shiver me timbers, arced over and hit t' ground. Then ejection occured. Thankfully, me hearties, thar was no damage t' t' rocket. This ill fated flight can be seen here.

Even though t' first flight was nay a good one, t' adapter seemed t' have worked as advertised and I wanted to give it a second try. Avast! This time I loaded a 1/2A3-2. Begad! T' flight be much better but problems began at apogee. Instead of ejectin' t' streamer, shiver me timbers, t' charge ejected t' motor mount. Avast! Arrr! T' rocket came down ballistically, glanced off t' GSE truck and hit t' ground. Avast! T' only damage was some minor crumplin' o' t' BT. Ya scallywag! T' adapter be never found. Begad! A video of the second ill fated flight can be seen here.

Recovery:
My experience with this adapter is nay t' greatest but I think this is partially because I be usin' in a friction fit rocket. Ya scallywag! If t' adapter had been mounted as designed in a motor tube with an engine hook, ya bilge rat, arrr, it should have performed fine, assumin' a proper motor selection t' begin with.

Flight Rating: 4 out o' 5

Summary:
For adaptin' motors, it works. Be wary o' friction fit applications, however.

Overall Rating: 3 out o' 5