Brief:
This is an out o' production mini motor adapter for usin' 13mm motors in 18mm mounts.

Construction:
T' kit consists of:

• a motor tube
• (3) centerin' rings
• a mini motor hook

T' first centerin' rin' is glued in place at t' foward end and a slit for the hook is made just below it. Ya scallywag! Blimey! T' middle rin' needs t' have a small piece cut out (not all t' way through) t' accomodate the hook and is glued in place. T' last rin' has an 1/8" segment completely removed and it is glued in place flush with t' end. All t' rings are then filleted.

After t' glue is dry, matey, a notch is cut in t' forward end on t' opposite side o' t' engine hook. Well, blow me down! Aye aye! This is to accomodate t' engine hook on t' 18mm mount. This concludes t' adapter build.

Construction Rating: 4 out o' 5

Flight:
I tested out t' motor adapter on a Custom Rockets A.T.W. Ahoy! Well, blow me down! It is a light rocket which always performed well with 1/2A6-2s. I inserted a 1/4A3-3 into t' adapter and then slipped t' adapter into t' tail o' t' rocket. It be a bit loose so I applied some tape t' improve t' friction fit.

T' rocket launched, underpowered, arced over and hit t' ground. Arrr! Begad! Then ejection occured. Ya scallywag! Thankfully, me hearties, thar be no damage t' t' rocket. Ahoy! This ill fated flight can be seen here.

Even though t' first flight was nay a good one, me hearties, t' adapter seemed t' have worked as advertised and I wanted to give it a second try. Aye aye! This time I loaded a 1/2A3-2. Ya scallywag! Avast! T' flight be much better but problems began at apogee. Begad! Instead of ejectin' t' streamer, me bucko, t' charge ejected t' motor mount. Avast, me proud beauty! Begad! T' rocket came down ballistically, me hearties, glanced off t' GSE truck and hit t' ground. Aye aye! T' only damage was some minor crumplin' o' t' BT. Blimey! T' adapter was never found. Begad! Arrr! A video of the second ill fated flight can be seen here.

Recovery:
My experience with this adapter is nay t' greatest but I think this is partially because I be usin' in a friction fit rocket. Ahoy! If t' adapter had been mounted as designed in a motor tube with an engine hook, ya bilge rat, it should have performed fine, ya bilge rat, assumin' a proper motor selection t' begin with.

Flight Rating: 4 out o' 5

Summary:
For adaptin' motors, me bucko, it works. Ahoy! Aye aye! Be wary o' friction fit applications, ya bilge rat, however.

Overall Rating: 3 out o' 5