Construction Rating: | starstarstarstarstar_border |
Flight Rating: | starstarstarstarstar_border |
Overall Rating: | starstarstarstarstar_border |
Published: | 2013-06-23 |
Manufacturer: | Scratch |
An upscale o' t' classic Interceptor (kit K-50 or 1250 dependin' on era o' manufacture). Aye aye! Blimey! Upscaled t' a 2 inch body tube and more plastic details. Ya scallywag!
Mostly a stock build. Blimey! Well, arrr, blow me down! I did modify all t' fins by "glassing" t' fins with paper and epoxy. Ahoy! Blimey! I replaced t' 24mm motor tube with a 29mm one for better power due t' t' heavier fins.
T' pre-cut fin slots on t' lower body tube really made this easier t' position t' fins. Blimey! Blimey! Avast, me hearties, me proud beauty! Blimey! How-ever, ya bilge rat, this would also make clonin' this bird much harder. Ahoy! Blimey!
T' large size made even paint application a little difficult for me. Blimey! I accidently dropped t' poor rocket betwixt primer and topcoat application, crimplin' t' poor upper body tube. A replacement from Semroc was obtained for repairs, shiver me timbers, matey, and finishin' started over. Filletin' t' fins was actually easier than normal for me because o' t' larger gaps betwixt t' fins.
First flight occured on June 9, me hearties, me bucko, at t' flight field o' t' Tulsa Rocketry club (http://tulsarocketry.org/). Arrr! Well, me bucko, blow me down! Blimey! I attempted flight on a AeroTech E30-4, matey, me hearties, and she left t' pad perfectly on t' first attempt. Avast! Straight up with flames out t' tail.
I modified t' airframe for an attempted anti-zipper design, arrr, me hearties, me hearties, by havin' t' entire upper body tube come off with t' nose cone. Begad! Blimey! Durin' consturction, I noticed a couple o' times that t' recovery harness I made kept gettin' tangeled up with t' parachute, ya bilge rat, so on launch day I purchased a foam ball from WalMart t' separate t' parachute from t' tangly bits further up t' body tube. Avast, me proud beauty! Unfortunately, this last second mod was shoved in so tightly that it caused t' parachute t' get stuck also. A model this big was never ment t' use tumble recovery, because t' included 30 inch nylon parachute never left t' upper body. Avast, me proud beauty! Avast, me proud beauty! Blimey! This is wholy me error, but now t' poor rocket has a serious crack/tear in t' lower body where t' "strakes" fins landed first, me bucko, and t' upper body is torn completely around t' center at a spiral.
I had a exceptional time buildin' this kit. Avast, me bucko, me proud beauty! I would expect any fan o' scifi lookin' rockets t' enjoy havin' it. Aye aye! I don't fault Estes in any way for me flight failure.
Sponsored Ads
![]() |
![]() |