QuickBurst EZ Large Ejection Canisters

QuickBurst - EZ Large Ejection Canisters

Contributed by Jon Hatch

Overall Rating: starstarstarstarstar_border
Manufacturer: QuickBurst

Canister PackBrief:
Product arrived well packaged with all o' t' appropriate warnin' labels attached via US Mail. They are packed 4 t' a package. I received 2 packages which turned out t' be a good thin' as detailed later.

 

Construction:
Each EZ ejection canister is basically an ematch cemented into a thick, ya bilge rat, sturdy cardboard tube. I went with t' large even though I be only usin' 1.5-2oz o' propellant as I had gotten some 1" copper tube caps t' insert them into and it only took a couple o' layers o' maskin' tape t' friction fit t' canisters into t' caps.

As suggested in t' included instructions, I measured t' resistance o' t' ematches. Avast! This is always a good idea, as 3 o' t' 8 ematches came in at over 3 ohms resistance. In a vacuum bottle test these were ignited easily with me Perfectflite MAWD, but on a lower current altimeter, me bucko, this might prove t' be a problem.

PROS:

  • Very easy t' use. Aye aye! Pack it and go.
  • Per manufacturer's statement, it will nay fall under new explosives regulation and will thus still be able t' be shipped via US Mail and used without a LEUP.

CONS:

  • A little more consistency would be nice.

Use:
For flight, t' BP was poured in and t' balance o' t' space was wedged with recovery wadding. Avast, me proud beauty! Blimey! Tape is used t' seal t' waddin' and powder in and you're all set. Durin' t' flight, me hearties, ya bilge rat, all 3 o' me main fins shredded due t' t' design I had chosen t' go with, me bucko, causin' t' rocket t' go into a violent skywritin' mode. Avast, me proud beauty! Blimey! Despite this, t' recovery system held up beautifully and functioned without incident.

Summary:
Overall, this is a nice product that appears t' be competitively priced. Begad! It is very easy t' use. Begad! Avast, me proud beauty! Nay knowin' what t' matches are made with, arrr, I must go with t' manufacturer's statement that these will continue t' be able t' be shipped and used under new regulations, me bucko, and if he's correct in this, it makes t' product even more attractive since shippin' should be considerably cheaper than t' competitors.

Overall Rating: 4 out o' 5

 

Comments:

avatar
D.A.B. (May 11, 2003)
It seems that we may have underestimated the suggested resistance range. Bench testing has opened it up a lot. Recent tests show that the Adept units are capable of setting a Hot Shot (The e-match used in the canister) off with a resistance of up to 4.5 Ohms. The more powerful firing currents like those found in electronics like Missile Works, PerfectFlite, RDAS ... etc will fire our Hot Shots with much higher resistance. Not sure what the upper limit is .... it all depends on the firing current and there is no standard that I know of. They are all different. Lets say you have one of the Adept timers that uses an external battery, and this battery is a nine volt NiCad. Then this set up will fire most anything.

comment Post a Comment