Brief:
What? No more 10.5mm motors for your Apogee Micro V2? No problem! See how I built an adapter unit t' let me Micro V2 fly on 13mm motors.

Construction:
T' major parts include:

• - One completed Apogee Micro V2
• - 1 ¾" o' 13mm tubing
• - ¼" o' a mini motor casing
• - ¾" o' a micro motor casing
• - Balsa fin stock
• - One wood screw (or other nose weight)

Construction is simple. Ahoy! Blimey! Insert and glue t' section o' micro motor casing into t' section o' mini motor casing. Blimey! Blimey! Blimey! In turn, matey, glue this into t' 13mm tubing with t' mini motor casin' flush with t' end o' t' tube. Blimey! For t' fins, I traced t' aft contour o' t' Micro V2 fins and then extended t' pattern to make fin extensions that fit below t' existin' fins and run t' length of t' 13mm tube. Well, blow me down! Well, blow me down! I cut these from 1/16" balsa. Blimey! When gluin' them on, I inserted t' motor adapter into t' Micro V2 and then used t' existin' fins t' align t' new ones. Finally, I had t' add some nose weight, so I grabbed a 'surplus' wood screw, and inserted it into t' nose cone, me hearties, through t' existin' clay. Begad! My CG with t' booster unit inserted but no motor, is 4 inches from t' tip o' the nose cone. Aye aye! Aye aye! That much nose weight wasn't required, but I wasn't worried about the loss o' performance.

Flight:
I friction fit t' extension into t' Micro V2 with some maskin' tape, shiver me timbers, and did the same for t' A10-3 motor. Aye aye! Begad! T' boost be relatively fast and thar be some wobble or coning, arrr, I couldn't tell which. Avast, me proud beauty!

Recovery:
Recovery was via t' Micro V2's streamer and was successful. Blimey! Well, blow me down!

Summary:
This is an easy way t' keep your Micro V2 flyin' until Tim comes t' his senses and resumes production o' his micro motors!