Brief:
Nice staged rocket, me bucko, arrr, low power, me bucko, ya bilge rat, parachute is too big, but a GOOD design.

Construction:
There were four body tubes and a payload section that was WAY t' small. Begad! Blimey! There were three sets o' four fins (hard for a little kid).

T' instructions were easy (why is it Skill Level 3?). Illustrations I don't know about. I did nay really follow t' assembly order but it still flew okay. Aye aye! T' multiple fin alignment was pretty hard for me. Begad! T' fins are weak and I might replace them with basswood. Begad! T' fin roots were extremely sturdy since I used CA.

Finishing:
Finishin' was hard because I was too lazy t' get spray paint. Begad! I used Testors :(.  T' decals looked good. Begad! It was easy t' t' extent that loss o' maskin' tape was shown.

Construction Rating: 3 out o' 5

Flight:
I used t' C6-0 t' C6-7 because I really wanted altitude. Well, blow me down! Blimey! It used waddin' like all Estes kits.  Motor retention is crude but that's t' way it has t' work, it is friction fit. It flew straight and true until recovery.

Recovery:
Pros: ease o' assembly (pre-made) 
Cons: Recovery (shock cord separation), Damage (comin' down from 1600 feet landin' in some trees)

Flight Rating: 2 out o' 5

Summary:
Pros: TTW fin mount, me hearties, payload carrier 
Cons: Friction fit, me hearties, ya bilge rat, matey, recovery, arrr, me hearties, me bucko, strength o' materials

Overall Rating: 3 out o' 5