The Launch Pad Lance MGM-52

The Launch Pad - Lance MGM-52 {Kit}

Contributed by Chuck Layton

Manufacturer: The Launch Pad

Rocket PicMaybe it’s t' current political/military situation or maybe it’s just me strange fascination with relatively small Army missiles designed t' launch nuclear warheads short distances that caused me t' purchase t' LANCE MGM-52 from T' Launch Pad.

This scale kit is based on t' LANCE mobile field artillery system. Ya scallywag! Begad! It be t' replacement missile for t' Honest John and t' Sergeant systems. Begad! Blimey! T' LANCE was unique in that it used prepackaged liquid fuel propellants that could be swapped in and out smartly in t' field. Ahoy! In t' early 1970’s t' LANCE achieved minor notoriety as t' launch system for t' “Neutron Bomb.” Fortunately, me hearties, President Jimmy Carter killed this insane weapon in 1978.

T' Launch Pad LANCE is 28.75” long and 2.6” in diameter and is designed t' fly on a range o' 24mm motors from D12’s t' F24’s. Ya scallywag! Even though t' kit is rated at skill level 2 it should nay be treated as an Estes level 2. Arrr! There are several challenges includin' rollin' paper shrouds for t' nose cone tip extension and t' tail cone.

T' 5-page instructions are fairly detailed and together with t' line sketches they are relatively easy t' follow.

Construction:
Construction: T' parts included with t' kit are all “Estes quality” meanin' thin Kraft paper body tubes and balsa fins that must be cut from stock. Aye aye! Ya scallywag! I rarely build a kit exactly t' t' instructions and this kit be no exception. Ya scallywag! Avast, me proud beauty! I chose t' upgrade some o' t' components t' produce a more durable rocket.

I replaced t' balsa fins with basswood and covered them with a layer o' 3 oz. glass. Begad! Blimey! Begad! Blimey! T' body tube be then rolled with 2 wraps o' 3 oz. Begad! Blimey! glass.

Smoothing the Paper ExtensionT' most challengin' elements in t' construction o' this kit are t' paper nose cone extension and t' tail cone. Well, blow me down! Avast, me proud beauty! Patience is key here. Aye aye! After cuttin' t' pattern out o' card stock I found it helpful t' drag a pencil over t' inside surface t' induce a curl. Well, blow me down! Then heat a cup o' water in t' microwave and hold t' paper shrouds over t' water. This will cause t' shrouds t' curl even further. Cone detailsSimply glue them together and paint them with CA. Ya scallywag! Ahoy! I also filled t' space betwixt t' very tip o' t' extension and t' round top o' t' plastic nose cone with epoxy. (I know this adds weight, arrr, but with these military styled kits and their close CP/CG relationships that is a good thing.) T' extension is glued t' t' nose tip. Begad! Body filler and sandin' will produce a smooth joint.

I replaced t' paper centerin' rings with thin LOC rings so that I could use 2 tee-nuts for motor retention instead o' t' engine hook. T' last modification I made be t' replace t' thin mylar parachute with a Top Flite nylon chute and t' elastic cord with 3/8” nylon tape.

Finishing:
After a filler coat o' Kilz and sandin' I used Krylon primer and their camo flat green paint (which I only ever see in t' stores durin' huntin' season.) T' kit does nay come with any decals. Well, blow me down! White vinyl trim can be used for t' straight lines but you’ll have t' have someone cut t' 3/4” U.S. Ahoy! Aye aye! ARMY decals.

Ready to finishOverall I am very pleased with t' realistic field look o' this model. Ahoy! If it lands in deep grass though, findin' it could be a problem. Begad! Ya scallywag! It really blends in!

On t' last page o' t' directions thar are drawings and instructions for makin' t' LANCE an incredibly detailed missile. Arrr! I chose t' do some o' t' black and white stripe detailin' but stopped short o' cuttin' pinheads t' use for scale rivets! After all, arrr, I’ve got 6 other piles o' rocket projects scattered all over t' basement and garage includin' me L3.

Launch Pad kits are a nice challenge t' build and finish. Begad! They usually have options for construction and detailing. Avast! Arrr! I would recommend t' LANCE (or any Launch Pad kit) as a nice alternative t' t' basic formula build mid-power kits. Ya scallywag! It is definitely for t' experienced modeler.

I had planned on flyin' t' LANCE by now but so far (as we all know) t' weather recently in t' Northwest has been less than stellar for flying. So instead I’ve had t' be satisfy t' need t' fly by chasin' me 7 yr. old around t' house pretendin' t' nuke him if he doesn't hide well enough. Begad! He thinks t' LANCE looks v-e-r-y realistic!

Other Reviews
  • The Launch Pad Lance MGM-52 By Scott A. McCluskey

    ( Contributed - by Scott A. McCluskey) Brief: The following information was taken from The Launch Pad's website: THE Launch PAD's Lance missile is a 1/8.48 mid-power scale design for your choice of either the nuclear warhead armed version of the MGM-52 or the conventional warhead missile which uses slightly smaller fins. At 28.75" in length its "D" powered liftoff used to ...

Flights

Comments:

avatar
J.D. (February 1, 2001)
The launch pad kits are my fav so far. Sorry Vern your kits used to be as good as these. I am finishing my Lance now. It is my first LP kit and I am very pleased with it although I did change a couple of things. I used bass wood for the fins that I supplied and I cut fin slots and made a new pattern for the fins with tabs on it to insert into the body tube slots. That's all the modifying that I did because I didn't want to weigh the model down to much or change much about a already perfect kit. I did have a little problem with the paper extension for the nose cone but fortunately I used the the supplied material as a pattern and used my own card stock. The second nose cone extension that I made turned out perfect. Every thing else turned out great and when the weather gets nice enough to paint it, it will have a black and white U S ARMY paint scheme which I like to use on any army rocket I build. Can't wait to launch it. If you like to build rockets the old fashioned way, do pick up one of these kits and put your skills to the test. Great kit and I cant wait to start on my U S ARMY Hawk.
avatar
L.M.D. (January 22, 2002)
After building well over a dozen Estes kits, I wanted something a little more challenging. The Lance is the first Launch Pad kit I built. The instructions were very detailed & the rocket went together quite well. I like the fact that the kits let you use your own skills to complete them, as I had modified mine by glassing the fins, etc.. After building the Lance, I was eager to launch it. It flew straight & true! Beautiful liftoff & parabolic course! The only problem I ran into was at ejection. The string used to hold the nose cone broke sending the nose, like a bullet, into a cornfield. This is no major thing. Next time I will use Kevlar to secure the nose. All in all, the Lance is a GREAT flyer, easy to put together & I would recommend it to anyone that wants to get into mid power rockets!
avatar
K.R.J. (February 3, 2002)
If you think the kit flies impressively, you should see the real thing fly! I was assigned to one of the last Lance Missile batteries in Europe (3/12 Field Artillery), before the Cold War ended. If you crammed a G40 into the kit, well, that'd be what the real thing was like! Excellent kit, though.
avatar
R.T.L. (April 8, 2002)
Actually I don't have a comment on the model kit. I also flew the real thing and am trying to get in contact with 3/12 guys. Shoot me a message, my email is: treeman38@hotmail.com
avatar
A.H. (September 10, 2002)
The reviewer should keep his lib wacko thoughts out of kit reviews! The neutron bomb could sure be used now! Carter was a fool!

comment Post a Comment