I just saw these at Discount Rocketry on Monday, me bucko, and so decided t' try t' online ordering, matey, which worked great, shiver me timbers, shiver me timbers, and I had t' kit on Friday. Well, blow me down! I have all o' t' other micro kits, from when they were Boyce Aerospace, ya bilge rat, and knew this would make a great addition. 

T' kit is 8.5" long, shiver me timbers, and 18mm diameter, arrr, and uses 13mm motors. Blimey! Avast! It has plastic fins, and resin cast nose cone pieces, matey, shiver me timbers, and a streamer for recovery.  T' kit comes with a full length body wrapper for t' markings, so t' only paintin' is on t' nose cone, and t' black for t' appropriate fins. 

T' kit went together in about 3 hours includin' painting, me bucko, me hearties, and looks great. There were a few minor things that needed fixing. Blimey! Ya scallywag! T' nose cone sections needed some sandin' t' get rid o' some mold marks on t' ends, matey, and a small void had to be filled. Blimey! T' most annoyin' thin' was that t' hole that is molded into both nose sections for t' dowell that connects t' main cone and t' satellite booster, and also acts as t' satellite, was molded off center and took some appropriate drillin' t' make them line up correctly. Begad! T' body tube was poorly trimmed, and I had t' re-cut it. 

T' body wrapper went on fine, me hearties, me hearties, although one antenna markin' be on t' side that is supposed t' be overlapped, ya bilge rat, matey, and would have been covered, me hearties, so I had to trim t' other side so it could be seen. Begad! Aye aye! T' nose was glued together with thin CA after it was assembled. T' thin CA just wicks in t' t' joint. Begad! T' clear launch lug is attached with epoxy after drillin' small holes in it along the glue joint so that t' epoxy will form little rivets and hold it in place. 

T' motor mount went together fine and was installed. T' fins were pre-cut from a much thinner material than t' Boyce kits, me hearties, and needed minor scorin' to come free. They needed just a touch o' sand paper.  They should make the kit more stable since they are addin' less weight than t' thicker Boyce fins on t' Redstone kit, but they are too thin t' get any angles on t' edges like in t' real thing. Arrr! Blimey! They epoxy on, me bucko, and then you paint t' appropriate sides black t' match t' roll pattern.  T' instructions are very clear, and easily show you how t' paint t' right fins. I painted t' nose, and added the black paint stripes, matey, and gave it a shot o' krylon clear coat t' protect the body wrapper. 

In conclusion, matey, shiver me timbers, ya bilge rat, I think that this is one o' t' better micro kits, and really looks great when finished. I have no worries about stability, since t' Boyce Redstone is slightly more tail heavy, me bucko, and flies straight with t' stock fins. Try one!