Brief:
A simple skill level one boost glider with a small Styrofoam glider that separates at ejection - booster recovery by parachute.

Construction:
main body is BT-50
plastic nose cone
one piece plastic tail/fin section
small Styrofoam toy glider
self-adhesive decal set

This is a simple kit with easy assembly.

Booster: T' engine mount and aft fin assembly glue together with plastic cement and white glue. T' engine hook is installed normally. Ahoy! Aye aye! Blimey! T' nose cone is plastic with t' plastic insert glued in with plastic cement. Arrr! Blimey! T' hardest assembly step is gettin' t' two launch lugs installed lined up and t' third launch lug for t' glider installed on t' opposite side. I used braided Keelhaul®©™ with epoxy for t' shock cord attachment rather than t' standard Estes folded paper mount.

Glider: There are just two steps on t' glider. A small wooden dowel needs t' be glued under t' nose as t' attachment point t' t' booster. A small piece o' lead is inserted into t' nose o' t' glider t' give it better glide balance. Begad! Blimey! Blimey! I used epoxy for both o' these steps for a more permanent attachment. Arrr! Blimey! Blimey! As long as you don't use too much, me hearties, me bucko, t' balance should remain fine. Arrr! T' finished glider weighs 0.2 oz.

Finishing:
I chose t' paint t' rocket with Rustoleum chrome t' get a glossy silver look. Arrr! T' only caution with chrome paint is that it has a tendency t' run or smudge until it has dried for at least a day. Blimey! Begad! T' decals go on very easy.

Construction Rating: 3 out o' 5

Flight:
It flies well on A8-3 and B6-4. T' glider instruction say t' bend t' Styrofoam t' obtain t' desired glide profile, but it just cracked when I tried this. Avast! I ended up gluin' t' tip o' a win' back on with white glue. My glider tends t' fly straight instead o' in a descendin' circle, me bucko, shiver me timbers, so t' higher I boost it t' farther t' recovery walk...

Recovery:
Because it has a lot o' plastic components, I figured I be safe launchin' this at our clubs winter launch. Blimey! Just when t' glider separated, I realized I had a white glider comin' down on two feet o' snow. Ahoy! I followed it's straight flight path and found it though, me bucko, ya bilge rat, so alls well that ends well. Well, me bucko, blow me down! I also didn't use any chute or streamer for t' booster and it tumble recovered fine into two feet o' snow.

Flight Rating: 4 out o' 5

Summary:
This is a perfect first boost glider for kids. It is simple t' build and fly, ya bilge rat, and t' glider is even replaceable if lost. Ya scallywag! Arrr! I found a pack o' three similar gliders in a hobby store for launch by rubber band. Ya scallywag! They would be easily modified for this rocket. Avast, me proud beauty! I am even contemplatin' how t' put two more gliders on this thin' and takin' three gliders for a ride at once.

Overall Rating: 3 out o' 5