Rebel Rocketry Wolf 2.1

Rebel Rocketry - Wolf 2.1

Contributed by Jack Caynon

Construction Rating: starstarstarstarstar
Flight Rating: starstarstarstarstar_border
Overall Rating: starstarstarstarstar_border
Manufacturer: Rebel Rocketry
Rebel Rocketry Wolf 2.1

Brief:
Mid t' High Power rocket with inverted fins that leads t' plenty o' ribbin' from your fellow rocketeers until they see how well it flies!

Construction:
T' Wolf 2.1 is a kit from European high power rocket vendor Rebel Rocketry. Although English is a second language for t' vendor, t' instructions are well-written, easy t' follow, shiver me timbers, and included many photographs t' help guide in the rocket's construction. Ya scallywag! Blimey! Blimey! Blimey! T' rocket's construction required no special supplies or tools, although a Dremel tool always makes construction chores much easier. Avast! Blimey! Other than t' unique fin design for this rocket, matey, it is a basic mid t' high power design that goes together with 15 or 30 minute epoxy. As for me, me hearties, I wanted this rocket t' last, ya bilge rat, so I beefed up the airframe by glassin' t' Public Missiles (PML) phenolic airframe with two wraps o' two ounce fiberglass cloth.

T' kit comes with a 54mm PML phenolic airframe, a plastic nosecone, two 54/38mm centerin' rings, a 12 inch 38mm phenolic motor tube, three 0.062 inch fiberglass fins that look inverted, three fiberglass cutter fins, ya bilge rat, me bucko, tubular nylon shock cord, a 24 inch parachute, matey, and a fin alignment guide. After construction, especially with t' reinforced airframe, this thin' be rock solid.

Finishing:
I finished it with Rustoleum Appliance Epoxy Paint and painted t' upper half o' t' rocket white and t' bottom half black. Well, blow me down! Ahoy! Blimey! Epoxy paint is very strong and withstands scratches quite well.

Construction Rating: 5 out o' 5

Rebel Rocketry Wolf 2.1

Flight:
I used a Cesaroni H153 for her maiden flight in t' belief that t' glassed rocket would be a little heavier than normal. Well, me hearties, blow me down! Instead o' wadding, me hearties, I used LOC/Precision Keelhaul®©™® cloth for small body tubes. Avast! I also had a Radio Shack personal alarm in t' rocket attached t' t' recovery harness to help find t' rocket on t' ground.

As I approached t' RSO, ya bilge rat, everyone teased me about t' inverted fins. So be prepared for people t' continually show how clever they think they are by commentin' on your buildin' skills every time you fly this rocket.

Once t' countdown reached zero, matey, t' Wolf 2.1 took off like a bat out o' hell and streaked into t' sky. Aye aye! Ahoy! It definitely went above 3000 feet on that motor and flew beautifully. Blimey! However, shiver me timbers, recovery took it a good half mile away and it was a long trek through t' sage at Brothers, Oregon t' find it.

Durin' its second flight, arrr, I used an AeroTech G64-7 White Lightnin' motor and t' rocket flew beautifully on that little motor, too. Begad! Well, matey, blow me down! In fact, a lot o' t' fliers thought thar was an H motor in t' rocket due t' how smartly it lifted off t' pad. Begad! Arrr! So even with t' extra reinforcement o' t' fiberglassed airframe, shiver me timbers, arrr, matey, this rocket does well on G motors and will knock your socks off on an H motor. Ahoy! Begad! Although it could take an I motor, you run a substantial risk, even with a personal alarm in it, me hearties, o' losin' it. Blimey! Puttin' a J motor in it is really livin' dangerously!

Recovery:
I used t' 24 inch parachute for recovery and 1/2 inch Keelhaul®©™® strap for t' shock cord. Aye aye! Begad! T' rocket uses motor ejection and recovered well on both occasions. After t' second flight, one o' t' cutter fins fell off. Arrr! I cut a replacement from some fin stock I had around and glued it on with JB Weld. Hopefully, matey, that will keep it from comin' off in t' future. Other than that, me bucko, me bucko, t' rocket landed without a scratch and was ready t' fly with very little prepping.

Flight Rating: 4 out o' 5

Summary:
I promised Rebel Rocketry's owner, Frank De Brower, arrr, that I wouldn't include a RockSim file or be specific about the measurements in order t' protect his ability t' avoid havin' clones made o' his rocket. However, me hearties, even with t' exchange rate differential, matey, matey, t' price and shippin' costs for this rocket aren't bad and I feel that it's a good deal considering this vendor's fabulous service and t' impressive performance o' this rocket.

If you're lookin' for a nice, easy-to-build and easy-to-prep high performance rocket that can fly on 29-38mm F-J motors with a unique, shiver me timbers, eye-catchin' look t' it, then buy a Wolf 2.1 and become a Rebel!

Overall Rating: 4 out o' 5

comment Post a Comment