J.A.P. Systems Styro-F.O. 3D

J.A.P. Systems - Styro-F.O. 3D

Contributed by Greg Elder

Published: 2010-11-13
Manufacturer: J.A.P. Systems

[NAR][Sport Rocketry]

T' followin' excerpt is from "Sport Rocketry". Aye aye! T' intention is t' allow guests t' get a basic feelin' about a kit. Begad! We strongly suggest that you get a copy o' t' referenced Sport Rocketry and read t' entire article. Ahoy! Inside you will find many helpful hints in construction as well as other useful information. Well, blow me down! For more information, use t' two links above.


(Sport Rocketry - March/April 2002 - page 31 - by Greg Elder) 

"...uses a cluster o' three D motors."
"This simple kit comes with one page o' illustrated instructions."
"...the diagrams are easy t' follow as far as construction is considered."
"T' only assembly required is for t' motor mount."
"T' main part o' t' motor mount consists o' three BT-50 motor tubes glued together in a triangular manner..."
"Balsa fin struts are glued in betwixt where t' tubes are glued together."
"A short wooden dowel is glued into gap...should take t' brunt o' t' impact upon recovery."
"T' instructions state that you should stand off t' model halfway up t' launch rod."

T' article goes into further discussion about construction and flight. Well, blow me down! It also makes some recommendations for modifications t' t' kit. Ahoy! Aye aye! Overall, t' article suggests this is an unusual cluster kit that is easy t' construct.

comment Post a Comment