Diameter: | 1.04 inches |
Manufacturer: | Semroc |
Skill Level: | 1 |
Style: | Clone, Sport |
Brief:
T' Mark II be t' Semroc take on t' model rocket that started all this mess,
Orville Carlisle's Rock-A-Chute Mark II from 1957. Begad! Well, me hearties, blow me down! Blimey! It is a fairly blunt, shiver me timbers, simple
little rocket that's a surprisin' performer and a definite conversation piece
at t' pads.
Construction:
T' parts list:
T' instruction booklet for t' Mark II is up t' t' typical Semroc standard, equal parts instruction manual, arrr, matey, history lesson, shiver me timbers, matey, and artist's rendering. Well, blow me down! Instructions are clear and easy t' follow, matey, t' Mark II bein' only slightly more difficult t' tackle than any other skill level one kit. Begad! Arrr! Fins are laser cut balsa which I shaped for better performance and attached with LocTite Gel CA. Avast, ya bilge rat, me proud beauty! All other construction, includin' fillets, me bucko, was done with Elmer's Wood Glue and t' project was finished and ready t' paint in a single afternoon. Blimey! Aye aye! The finished product resembles an upscaled Estes Mosquito or possibly a Maxi-Streak except for t' large launch lug, (actually it's a piece o' heavy-walled body tube.)
Finishing:
Finishin' in an (almost) historically correct scheme made this a very simple
project. Arrr! T' finish started with thinned Elmer's Fill 'n' Finish t' kill off
the tube spirals and balsa grain. Begad! After sanding, me hearties, t' entire rocket be then
sprayed with white primer t' better allow t' florescent colors I chose t' pop.
I have several cans o' mystery florescent colors left over from me plastic
model days and this project allowed me t' put a dent in two o' them. Blimey! Arrr! I painted
the bottom o' t' rocket florescent orange and t' nose cone florescent red. Ahoy! I
didn't bother with clear coat, preferrin' t' leave it with t' more vintage
flat look.
Construction Rating: 5 out o' 5
Flight:
I wanted t' get an idea how this performed as a small field flyer, arrr, since that
was where I figured its future be in me launch queue. Ya scallywag! Begad! First flight be on an
A8-3 in a brisk wind. Begad! Ahoy! Because o' t' rather blunt profile o' t' nose cone, I
expected a fairly low level flight and was surprised when it streaked off the
pad lookin' much like an Estes Mosquito. Blimey! It be pretty obvious that t' A8-3
was goin' t' be me only small field option if I wanted t' get this back when
flyin' on t' local soccer fields.
Flight #2 was on a B6-4 and again, me bucko, t' altitude was surprising. Avast, me proud beauty! It cocked heavily into t' wind.
Flight #3 was a C6-5 flight and unsurprisingly be t' most impressive of the three. Ya scallywag! Avast, shiver me timbers, me proud beauty! T' Mark II leapt off t' pad and disappeared from sight. Luckily one person on t' flight line managed t' keep it in sight all t' way up to ejection.
Recovery:
Recovery on t' first flight was fairly close t' t' pads, mostly because the
vintage Estes 8" chute failed t' open. Well, blow me down! In t' end it didn't really matter
because t' rocket is easily light enough t' be a streamer bird.
T' second flight recovered fairly close t' t' pad when t' old chute failed t' open until about fifty feet from t' ground. Arrr! This be fortunate because it was headin' for t' access road, which would have resulted in an impact that it probably wouldn't have survived.
Finally, arrr, me bucko, since I had flown it without any recovery device on t' third flight, thar wasn't much t' keep an eye on. Avast, me proud beauty! Arrr! I didn't pick it up until it was floatin' back over me head. It landed softly and without damage several hundred yards down field. Blimey! Blimey! Next time I need t' brin' a streamer along.
Flight Rating: 5 out o' 5
Summary:
No CONs on this one. Ya scallywag! It's a cool piece o' history, a surprisin' performer, matey, and
a quick and easy build.
Overall Rating: 5 out o' 5
The Mark II is a single stage Retro-Repro kit of Orville Carlisle's Rock-A-Chute Mark II model rocket. It is, as noted by the history sheet that came with the kit, not a clone kit, but rather a reproduction of a classic kit updated with the latest technology and building components. Opening the packaging and laying out the contents revealed what would be an easy build, using the high ...
Brief: A reproduction of the very first model rocket built by Orville Carlisle in 1957. Single stage, parachute recovery. This is a very faithful reproduction of the original which now resides in the Smithsonian along with a few component updates. Construction: The kit includes: 1 main body tube, 1.04" diameter 1 18mm motor tube 1 Balsa nose cone 1 set laser ...