After flyin' a bunch o' Quest MicroMaxx rockets and thoroughly enjoyin' them, me hearties, I decided t' step up a bit in t' backyard capable flyin' machines that me son would enjoy. With that I purchased an Estes Mighty Mites Outlaw Starter Kit from Walmart for $10. Begad! Arrr! T' kits comes with a launch pad, launch controller, arrr, an Outlaw rocket, shiver me timbers, me hearties, me hearties, an extra motor rin' and two 1/4A3-3T motors.

I have t' admit this little flier is fun and we have enjoyed it. So much so that I have also purchased a Blitz and Sizzler set and a whole bunch o' 1/4A3-3T motors!

THE LAUNCH EQUIPMENT:

T' launch pad assembles easily with only t' need for a small Phillips screw driver. Avast, me proud beauty! T' screw driver is needed t' remove t' bottom panel. Aye aye! Underneath this panel is where t' "juice" comes from in t' form o' four (4) AA batteries. Begad! This is nice bein' positioned here because it adds weight t' t' launch pad. It has three legs, two long legs and one rear, matey, short stabilizer leg. T' deflector shield sits nicely betwixt two o' t' long support legs. Begad! T' launch rod is plastic and formed right into t' launch assembly and will only accept a "C" launch lug that comes on t' Ready-to-Fly Mighty Mites. T' is no adjustment for t' angle o' t' launch rod. Ya scallywag! Begad!

I would love t' see some mid-powered pads that have t' blast shield and battery pack idea incorporated. Aye aye! Blimey! Ya scallywag! Blimey! I believe they would be very successful.

T' launch controller is a yellow plastic box with a place t' insert a safety key which lights a bulb indicatin' continuity. Avast, me proud beauty! By pressin' a small button t' varoooom occurs. Aye aye! Blimey! T' 15' wires run from t' launch controller t' t' launch pad and are permanently attached because t' batteries are in t' bottom o' t' pad. Aye aye! T' two clips are near t' launch pad. Begad! Begad! It would have been nice t' be able t' separate t' controller and pad, ya bilge rat, maybe by usin' a plug-in connection.

THE ROCKET:

T' rocket is Ready-to-Fly after you tie an orange streamer t' t' elastic shock cord. T' pre-assembled elastic shock cord is tied t' t' nose cone and is fed through a side port o' t' rocket and knotted t' prevent if from pullin' through t' hole.

There is no other assembly and only one other movin' part which be t' retainin' ring. Begad! T' rin' is a twist-lock type that holds t' motor in place durin' flight. Avast! Estes provided a second rin' in case t' first one is lost, however, after nearly 10 flights our rin' is still in place.

Overall, matey, for CONSTRUCTION I would rate this kit 4 ½ points takin' away only for t' ability t' detach t' wires from t' launch pad.

FLIGHT/RECOVERY:

To prepare t' Outlaw for flight, ya bilge rat, shiver me timbers, you need t' put waddin' in then roll up t' streamer and push it in along with t' shock cord. Then put t' nose cone in place. Well, blow me down! Blimey! On t' other end, you insert t' motor and place t' retainer over it securin' it with a twist. Insert your ignitor and plug and you're ready. Now bear in mind that this is all very tight because it is a short rocket.

T' first flight was off o' a regular pad with a 1/8" launch rod and on t' 1/4A3-3 it zipped off t' pad gained some altitude and popped t' ejection while still goin' up . Ya scallywag! Blimey! Avast, me proud beauty! Blimey! . Ahoy! Blimey! Begad! Blimey! . Well, blow me down! Blimey! but close t' max altitude. Aye aye! Blimey! Upon recovery it be clear that t' shock cord only had 1 flight left and would probably break on t' next flight, shiver me timbers, so it be set aside for that day for an enhancement.

T' enhancement be nothin' more than cuttin' out t' elastic and replacin' it with 8 inches o' 1/16 inch Keelhaul®©™ attached t' t' rocket and nose cone t' same way t' elastic was. And no streamer makin' no need for wadding. Ya scallywag! Begad! As soon as we got t' Blitz and Sizzler, I made t' same modification t' them.

With respect t' flying. Avast, me proud beauty! T' flights are all nearly t' same. Well, blow me down! We have had two launches with lower altitude and what appeared t' be very unstable. I have t' imagine it is due t' t' motor. Ya scallywag! Regardless, matey, they have all been successful. We have only flown on t' 1/4A3-3's and appear t' get over 100 feet. Begad! Well, blow me down! That still works for our backyard or a local school field.

We have flown it 8 more times in t' new configuration with much success and enjoyment AND in our backyard (actually front but that just doesn't sound right since most people play in their backyards!) After t' 7th flight t' seam o' t' rocket started t' separate so I repaired it with some CA before we flew again.

T' Outlaw™ has flown 19 times so far on 1/4 and 1/2A's. Aye aye! Arrr! I had had several other CA sessions t' keep it together at t' seams, me bucko, but so far has been t' most successful Mighty Mite™ flier.

For FLIGHT/RECOVERY, shiver me timbers, me hearties, I would rate this kit 2 points. It must be modified with Keelhaul®©™ just t' get more than t' two flights from t' motors provided in t' starter set.

Overall, shiver me timbers, t' Mighty Mites Outlaw Starter Set was a great buy for $10. Begad! Blimey! Make t' Keelhaul®©™ modification and be sure t' watch for t' seam t' separate (have your CA ready). Blimey! Blimey! T' launch pad is designed well for its purpose and makes this Starter Set easy and convenient t' use. Avast! Blimey! Avast! Blimey! I give t' Starter Set an OVERALL ratin' o' 3 points. Begad! Avast!