Brief:
This is a very small, ya bilge rat, futuristic lookin' rocket. Avast, me proud beauty! Overall t' kit is pretty good, ya bilge rat, it is just tiny. Arrr!

Construction:
T' kit comes with two body tubes, one o' which be t' motor mount, a tube coupler, engine block, engine hook, balsa fins and nose cone, water slide decals, rubber shock cord, and an eye hook for t' nose cone.

When I first bought this model it be in a cardboard box instead o' t' regular plastic bag t' kits usually come in. Avast, me proud beauty! Begad! When I opened t' kit up at home I was surprised t' find a balsa nose cone and water slide decals (thank you for listenin' t' us Estes). Ya scallywag! T' instructions were pretty good besides t' fact that t' main win' placement measurements are nay given. Avast, me proud beauty! I mounted mine too far back but it was no real problem.

T' balsa in this kit is very thin and flimsy due t' t' size o' t' model, matey, shiver me timbers, which is very small. Begad! T' engine hook is actually on t' outside o' t' body, but with some wood filler and sand paper I managed t' cover it up rather nicely. Begad!

Most o' t' kit be just a straight forward, Estes build. There was nothin' special or very hard about this kit at all. Begad! Blimey! One thin' I did do, that I do t' ALL o' me Estes kits is t' nay use t' tri fold method t' attach t' shock cord, instead I used a steel fishin' leader. Begad! Blimey! I filed a groove into t' tube coupler and secured t' leader around that.

T' parachute was a plain white plastic chute. Blimey! Arrr! T' body tube bein' so small t' parachute really has t' be folded up good for it t' fit inside and I was worried about it bein' able t' deploy. Ahoy! Blimey!

Finishing:
Finishin' this kit was rather easy, arrr, even though I did a lot o' fillin' on it. Ahoy! Avast! Getting betwixt t' lower fins t' sand where I moulded around t' motor hook be t' most difficult part. Well, blow me down! After fillin' the balsa and spirals and mouldin' everythin' smooth I painted t' rocket with a couple coats o' primer and then three coats o' white paint. Ahoy! Avast!

T' decals included in t' kit are great. Blimey! I am glad t' see water slide decals included with t' model. Avast, me proud beauty! Arrr! There is no direction really given on placin' t' decals other than a very small picture o' t' top and bottom o' t' display model. Avast, me proud beauty! There are plenty o' decals included, in fact I did nay even use them all and I felt t' model came out rather nice looking.

After applyin' t' decals and allowin' them t' set over night I coated t' entire rocket with Krylon crystal clear gloss. I let t' rocket set up in me hobby room for a few days waitin' on it t' dry and t' winds t' die down so I could launch t' rocket.

Construction Rating: 4 out o' 5

Flight:
I flew this rocket on a B6-4 for its first flight. Avast! T' winds were up above 10 MPH and thar was a light snow falling. Avast! Temperatures at t' time were below freezing. Avast, me proud beauty! Ahoy! T' flight be picture perfect. Begad! I did have t' aim t' launch pad into t' wind, shiver me timbers, but t' rocket flew very nicely. At apogee t' nose cone blew just fine, draggin' the parachute out with it, shiver me timbers, however t' parachute did NOT open, in fact t' shroud lines did nay even unwrap from t' chute. Nay sure if it was t' cold or t' chute was packed too tight or both, ya bilge rat, but t' model came down and stuck t' tail fin about 2 inches into t' dirt. Begad! Lucky for me thar was absolutely no damage, arrr, me hearties, matey, nay even a chip in t' finish, which surprised me seein' as t' ground be pretty cold and frozen.

Recovery:
I replaced t' Estes tri-fold with a steel fishin' leader t' secure t' shock cord and replaced t' shock cord with a piece o' elastic 2.5X longer than t' one included. Avast, me proud beauty! Aye aye! Recovery could have gone better for me, but if proper care is taken in packin' t' parachute and maybe addin' some talc I am sure it would come down fine. Seein' as t' model is very light weight as long as proper build techniques are used you should be able t' recover it on t' supplied parachute with no damage at all.

Flight Rating: 4 out o' 5

Summary:
In closin' I would like t' say that this is one very good lookin' model rocket. Blimey! It may be small, but it is a great flyer and a very satisfyin' rocket t' build.

Overall Rating: 4 out o' 5