Add spin tabs (2011-06-26)

Learn how to add spin tabs to the fins of a model rocket. This how-to video shows the construction of the model rocket with the spin tabs on the rear edge.

Angled wood joint for model rockets (2011-06-03)

When creating spin tabs on the bottom of the fins on your model rocket, you should bevel the edges so that you maximize the strength of the joint. It also makes it much more attractive. In this video, you'll see the simple technique you can use to create the perfect beveled edges.

Cutting small diameter model rocket tubes (2011-06-26)

Cutting body tubes for model rockets is a skill that you'll need if you want to make your own designs. Here you'll see one of the techniques that works great for small tubes.

How To Build GREAT Model Rockets (2011-06-26)

Building GREAT model rockets is all about techniques. I'd like to show you those techniques.

How to Make A Paper Transition for Model Rockets - Part 3 (2011-07-05)

Making a paper transition section for a model rocket - Part 3. Here you'll see the secret glue that I use to get a perfect curve on the outer surface of the transition. Then we'll start building the transition section structure so that you end up with a strong rocket

Make Your Own Rocket Tube Couplers (2011-06-26)

If you want to create a long model rocket from two shorter tubes, you'll need a tube coupler. Here you'll see the steps to make your own! To get your own high-quality tubes,

Mount an altimeter in a model rocket (2011-06-28)

How to mount an altimeter into a model rocket. There are many good rockets that can be used for science fair projects, but often the payload bay is too short for the altimeter. In this video, you'll see how to modify the rocket to make the altimeter fit.

selecting motors (2011-07-04)

How to select rocket motors for the rocket kits found at the Apogee Components web site.

Slot-a-Tube (2011-06-17)

This model rocketry how-to video will show you the method to use to cut slots in a rocket body tube for use with through-the-wall fins. The end result is that the fins will be much stronger and can take hard landings without the fins snapping off.

Strengthening Centering Rings On Your Model Rockets (2011-06-26)

Want to make stronger engine mounts for your model rockets without going to expensive plywood rings? In this video you'll see three methods you can use to add strength to the rings without busting your budget or adding a lot of weight to your rocket.