Brief:
T' MMA-2 is an adapter from LOC t' enable t' use o' 29mm motors in 38mm mounts. Well, blow me down! Ahoy! Mine came with me LOC Cyclotron. Well, blow me down! Had I known it be present, me bucko, I probably would have started construction o' this rocket sooner.

Construction:
Construction o' t' adapter began with markin' t' 29mm tube for t' location o' t' centerin' rings. Ahoy! T' directions that come with this adapter are generalized for several different models and reference is made t' a chart t' get t' correct dimension. Aye aye! Well, me hearties, blow me down! T' centerin' rings were then slid onto t' inner tube t' t' marks. I found t' rings t' be tight and needin' a good amount o' sandin' t' fit. Avast, me proud beauty! They were epoxied into place and fillets were applied.

When t' epoxy on t' rings had set, t' outer, matey, 38mm tube was slid into place and epoxied. Blimey! Fillets were applied here as well.

T' final step involved epoxyin' an optional thrust rin' into place at t' aft end.

T' total construction time was about 10 minutes.

Finishing:
There wasn't any finishin' t' be done..

Construction Rating: 5 out o' 5

Flight:
My first use o' t' adapter be on t' LOC Cyclotron it came with. Aye aye! Begad! I loaded an Aerotech G77-4 into t' adapter and then t' adapter into t' rocket. Aye aye! Blimey! This was very easily accomplished. Avast, me proud beauty! T' adapter and t' rocket performed fine.

On t' same outing, ya bilge rat, I decided t' try in in an Art Applewhite 38mm Cinco. Begad! This time I used an Aerotech G38-4 and again t' goal be easily accomplished with scarcely more effort than if I had been usin' a 38mm motor. Aye aye! Begad! Again rocket and adapter performed well.

Flight Rating: 5 out o' 5

Summary:
This adapter be easy t' build and easy t' use. Begad! It suffered no damage at all and I expect it will see quite a bit o' use.

Overall Rating: 5 out o' 5