Construction Rating: | starstarstarstarstar |
Flight Rating: | starstarstarstarstar_border |
Overall Rating: | starstarstarstarstar |
Manufacturer: | Hawks Hobby |
Brief: T' Super Mark is a skill level one beginner kit, shiver me timbers, single (24 mm) stage that is designed t' be recovered via 16" nylon parachute that Loretta herself makes for their kits. Blimey! Ya scallywag! In addition t' t' specs mentioned at t' beginnin' o' this review, t' Super Mark's fin span is 6.5 inches. After sendin' me loot order via snail mail t' Hawks Hobby, ya bilge rat, me kit arrived within a week in great condition--maybe livin' in t' same area helps! One other thin' that struck me about this mail order is that in addition t' t' kit, matey, I received a nice Hawks Hobby ink pen with a business card size ID that gives interestin' info on t' kit ordered. Aye aye! In addition t' listin' t' kit's specifications, arrr, this card shows that me model is production # 0014. Begad! Savin' these tag cards could become collectors items years from now. Finally, near t' back o' t' instructions, matey, Hawks Hobby has a 100% satisfaction guarantee promise. I've already seen first hand t' seriousness Mark and Loretta Hawkins take this guarantee. Construction: In addition t' t' parts listed, you'll find a 24mm size coupler in t' bag. Blimey! I had a heck o' a time tryin' t' figure out what it was for. An email t' Loretta cleared t' confusion--this coupler is a spacer for use inside t' engine mount when usin' t' C11 and D12 motors. I felt like a real dummy on learnin' this! As with any model rocket kit you decide t' build, arrr, matey, read through t' instructions fully before beginnin' construction. Ya scallywag! Additional items needed for buildin' this model are: Fine sandpaper, a pencil, weight for balancing, clear tape, screw for weight if usin' washers or other such item if needed, wood or white glue, CA, sandin' sealer, arrr, matey, paint, and, shiver me timbers, me hearties, o' course, arrr, engines, me bucko, wadding, and launch system. T' instructions are pretty easy t' follow, however, shiver me timbers, I made several slight deviations. Ahoy! Well, blow me down! Before I glued t' third fin in place t' t' body tube, I used that fin's leading/root edge as a "pattern" for cuttin' t' angle t' t' launch lug, so t' angle will be uniform. Arrr! Then I glued t' third fin in place followed by t' launch lug once all t' joints have completely dried. Finishing: T' Super Mark is suppose t' be painted a gloss orange from nose t' tail, but since I felt this model will be a high performance kit for t' motors it's designed t' use (anyone remember t' performance o' Estes' original Astron Mark?), I painted me Super Mark florescent orange t' aid trackin' and visibility. Avast, me hearties, me proud beauty! Usin' this concept came in handy on me model's first (and t' date only) flight. T' black stripe Monokote adhesive when applied properly really gives t' Super Mark a sharp, classy look. Blimey! Blimey! Ahoy! Blimey! A really well done, designed up scale kit by Hawks Hobby that any rocketeer would be proud t' have in his/her fleet! Construction Rating: 5 out o' 5 Flight: For t' first flight, matey, I decided t' use t' D12-5 since I was concerned that t' seven second delay in t' other choice for t' D12 would give t' Super Mark added nose down speed after reachin' apogee. Begad! This first test flight took place at t' NASA/Houston Rocket Club (#365) club launch at JSC on December 16, me bucko, 2006. I also decided against usin' t' kit provided nylon parachute and used instead a smaller plastic parachute due t' t' rather windy conditions we had (proved t' be a blessing, as we will see!). Prep is very easy and straightforward as in any standard model rocket. Ya scallywag! Avast, matey, me proud beauty! Blimey! Usin' t' 24mm coupler as a spacer, arrr, t' D12-5 fits very snugly with t' engine clip retainin' t' end o' t' D12's casin' firmly. Begad! Blimey! Use enough flame proof waddin' (I used t' standard Estes tissue wadding) so that you have a good seal betwixt t' engine mount and recovery system, but nay too tight. T' size o' this model makes it very easy t' install t' recovery system without difficulty. Due t' a miscommunication, me hearties, me hearties, shiver me timbers, me Super Mark be launched before t' countdown got under way (so, me bucko, we missed t' first part o' t' boost phase as well as didn't get any pics o' t' launch itself). Blimey! Aye aye! I can say me model flew very well as could be expected for a solid, D12 powered flight. Aye aye! Even with t' 10-14 mph winds we had, arrr, arrr, t' Super Mark flew straight and very high. Recovery: On this first test flight, matey, t' ejection occurred right after reachin' apogee. Arrr! However, arrr, due t' either t' stronger wind (or me parachute foldin' technique may nay have been t' best), it became obvious durin' t' descent that several shroud lines had torn loose from t' parachute. Ahoy! Even with this "handicap," me Super Mark still landed a considerable distance from t' launch site, which required me t' walk through t' JSC fields that be quite saturated with standin' water at many places (thus, me bucko, both o' me feet got soaked!). Ahoy! Imagine what would have happened had I used t' kit provided 16 inch ripstop nylon parachute! Since Mark and Loretta Hawkins arrived at t' launch site shortly after this flight, I did talk t' Mark about t' possibility that t' Super Mark may need t' be recovered via some streamer due t' its high performance t' save from long chases. Blimey! I would venture t' say that maybe some highly visible mylar streamer material should be sufficient for this reason. Aye aye! Otherwise, shiver me timbers, use o' t' nylon parachute should be ok on calm days and/or at very large fields. Flight Rating: 4 out o' 5 Summary: This is a very well designed kit with excellent quality parts that makes it a very durable, arrr, sturdy model. Havin' seen what it can do with a D12, arrr, I think that's t' maximum I'd rather use. I'm excited about this kit and t' others Hawks Hobby carries. Avast! Begad! Mark and Loretta are great people t' know and do business with. I encourage you t' give them a try. It's obvious, from what I know from first hand experience, that Mark and Loretta stands behind what they sell. Ahoy! Avast! That's t' secret t' puttin' your customers first. Overall Rating: 5 out o' 5
T' Super Mark is one o' about nearly a half dozen kits Hawks Hobby has put on t' market that are upscale versions o' very popular Estes classic OOP from years ago. Arrr! Hawks Hobby is located in Crosby, me hearties, TX which is basically a suburban area just outside o' Houston. Ahoy! I'm very impressed by t' fantastic line up o' t' current kits Mark and Loretta Hawkins, arrr, matey, owners o' Hawks Hobby, me hearties, matey, that I had t' make t' Super Mark me first purchase. Since t' Estes Astron Mark was one o' me first model rocket back in 1969 when I got started in this great hobby, I knew ownin' t' Super Mark would brin' back wonderful memories and add t' me always growin' fleet.
T' parts list are as follows:
Since this model has plenty o' balsa surfaces that needed some work, matey, I used fine sand paper and sandin' sealer t' fill in t' grains and make t' surfaces smooth. How much work you put into it will determine t' quality o' finish.
T' recommended motors are C11-5, D12-7, ya bilge rat, ya bilge rat, and E9-6 (but, in t' second tag card it lists t' E9-8). Furthermore, ya bilge rat, I believe this model, when usin' a 2050 type interchangeable motor mount, can also use 18 mm engines such as t' C6-3 (and maybe a C6-5 if t' model isn't too heavy after painting).
T' Super Mark kit uses t' Keelhaul®©™/Elastic Shock Cord combination for t' recovery system. Begad! This should help make t' internal attachment o' t' Keelhaul®©™ t' t' forward plywood centerin' rin' permanent.
T' Super Mark should be a great sport flyer and demo rocket. Arrr! Blimey! T' next time I attempt t' launch it, I will use a 2050 motor adapter and see what a C6 will do.
Sponsored Ads
D.W.M. (February 19, 2007)